SK-YJ000XYY-KP 100014

The filter is one of the most important consumables in the smoking absorber, and regular replacement of the filter is the key to maintaining efficient operation of the smoking absorber. The following is a guide on the replacement cycle and replacement method of the filter:

I. Replacement Cycle

1.Frequency of Use:

– The replacement cycle of the filter usually depends on the frequency of use and the amount of smoke in the working environment. In high-frequency use or in a smoky environment, the filter needs to be replaced more frequently.

2.Manufacturer Recommendations:

– Most manufacturers will provide recommended replacement cycles for filters, which can usually be found in the product manual. These recommendations should be regarded as the minimum replacement frequency.

3.Observation and Testing:

– If a decrease in suction or a reduction in the efficiency of the smoking absorber is observed, this may be a sign that the filter is clogged, and the filter should be replaced immediately.

II. Replacement Method

The steps to replace the filter of the smoking absorber are usually as follows:

1.Prepare Tools and New Filters:

– Before starting, prepare new filters and possible tools (such as screwdrivers). Make sure to purchase a filter compatible with the smoking absorber model.

2.Disconnect the Power:

– Before replacing the filter, make sure to disconnect the power supply of the smoking absorber to avoid electrical accidents.

3.Remove the Old Filter:

– Open the filter compartment door of the smoking absorber. This may require removing some screws or undoing the fasteners.

– Carefully take out the old filter, taking care not to let the dust on the filter fall off.

4.Clean the Filter Slot:

– Use a clean cloth or soft brush to clean the filter slot and surrounding areas, ensuring that there is no dust or particle residue.

5.Install the New Filter:

– Place the new filter correctly in the filter slot, ensuring that it fits evenly without being deflected or having gaps.

– If the filter has a clear intake and exhaust side, please ensure the direction is correct.

6.Reassemble and Test:

– Reinstall all disassembled parts and secure all screws and fasteners.

– Reconnect the power supply, turn on the smoking absorber, and check if the new filter is working properly.

III. Maintenance Tips

– Record the Replacement Date: When replacing the filter, record the date and usage situation to track the service life of the filter and plan the next replacement.

– Backup Filter: It is recommended to always keep at least one set of backup filters so that they can be replaced immediately when needed, reducing work interruptions.

By following these steps and suggestions, it can be ensured that the filter of the smoking absorber is always in the best condition, thereby ensuring the efficient operation of the equipment and the safety of the operating environment.